Filter
Top Products
Installing and Configuring PPU Software
Configuring PPU Software
Chapter 332
Manually Starting the ppud Daemon
The ppud daemon is started automatically when you specify the utility
meter using the /usr/sbin/ppuconfig -m meter command. It is also
automatically started at system boot if a utility meter is configured.
However, the ppud daemon’s process may have inadvertently been killed
on the system/partition. If the ppud daemon is not running on your PPU
system/partition, you need to start it manually.
NOTE The ppud daemon must be running on each PPU system/partition,
including virtual partitions. If the ppud daemon is not running on your
system/partition, utilization information is not sent to HP and 100%
utilization may be assumed.
To verify the ppud daemon is running, execute the following command:
/usr/bin/ps -e | grep ppud
You should see the ppud daemon listed as an active process on the
system/partition. If it is running, and the utility meter is properly
configured, utilization information is sent to HP and your PPU
system/partition is correctly configured.
If the ppud daemon is not listed as an active process, you can manually
start the ppud daemon with the following command:
/sbin/init.d/ppu start