Filter
Top Products
Installing and Configuring PPU Software
Re-installing PPU Software
Chapter 3 33
Re-installing PPU Software
If you re-install HP-UX on a PPU system (for example, installing HP-UX
by either cold-installing or installing from a “golden image”), you need to
perform the following steps to restore your PPU configuration:
Step 1. Manually save your PPU configuration file by backing up the following
file: /etc/ppu/ppu_config
Step 2. Install the PPU software (see “Installing PPU Software” on page 26 for
details)
Step 3. Restore your PPU configuration file (from
Step 1): /etc/ppu/ppu_config
Step 4. Start the ppud daemon (see “Manually Starting the ppud Daemon” on
page 32 for details)
NOTE An alternative method is to: install the PPU software and configure the
utility meter, thus starting the ppud daemon.