Filter
Top Products
17
Area Code
1. Press the CALLER ID-VOL (- or +) button to scroll to the AREA CODE menu.
2. Press MUTE/PROG button to enter the menu. SET AREA CODE - - - shows in
the display.
3. Use the touch-tone pad to enter your 3-digit area code.
4. Press the MUTE/PROG button to confirm. You will hear a confirmation tone
and the new area code shows in the display.
NOTE: To restore the default setting to - - -, press and release DELETE when “SET
AREA CODE” shows in the display.
Key Tone
1. Press the CALLER ID-VOL (- or +) button to scroll to the KEY TONE menu.
2. Press MUTE/PROG button to enter the menu. SET KEY TONE 1ON 2 OFF
shows in the display.
3. Use the touch tone pad on the handset to select 1 or 2, or use the CALLER
ID-VOL (- or +) button to scroll to your selection. 1ON is the default setting.
4. Press the MUTE/PROG button to confirm and the key tone setting shows in
the display.
Registration
Your dual handsets are pre-registered and ready to use. It is not recommended
that a handset be registered again unless absolutely necessary.
1. If necessary, press the MUTE/PROG button to go to the REGISTRATION
menu. The default is 2 NO.
2. Use the touch-tone pad to select 1 for YES or 2 for NO. Or use the CALLER
ID-VOL (- or +) button to scroll to 1 YES or 2 NO.
3. If you select 1 YES, press the MUTE/PROG button to confirm your selection.
HOLD BASE PAGE WAIT FOR BEEP shows in the display.
4. Press and hold the page button on the base unit until you hear a long tone at
the handset. HANDSET X REGISTERED shows in the handset display, where
X is the handset number. You will hear a confirmation tone.