Filter
Top Products
19
NOTE - IT IS IMPORTANT TO:
! Aim the silver stripe of the Light Wand vertically toward the upper portion of
the body.
! Keep the body site to be measured relaxed (do not permit subject to flex
muscle area being measured).
! Use the Light Shield to block the external light. ALWAYS avoid
measurements under strong lights (e.g. direct sunlight) because errors may
occur.
CAUTION: Do not move the Light Wand while the decimal point is
illuminated. The actual measurement is being made at
that time.
NOTE: This relative body fat is not a direct "Percentage" reading. This value, however, can be used as
a guide to monitor changes in fat distribution within the location measured.
! Press ENTER.
The display will then show a decimal point following the number "1". The number "2"
will then be displayed.
!
Remove the Light Wand and replace it on the same site on the body.
! Press ENTER.
The display will show a decimal point following the number "2".
6) The Relative Body Fat Reading is Displayed
To Measure Another Site or Repeat a Measurement
Place the Light Wand firmly on the particular body site and follow steps outlined in 6 and 7.
OFF Message
An OFF Message will appear and the FUTREX-5000A/WL Automatic Power Down feature will turn the unit OFF if the user
has not pressed any key for 6 minutes. To use the unit again, turn the Power Switch OFF and then ON again.