Filter
Top Products
12
NOTE:
IT IS IMPORTANT TO: Aim the silver stripe of the Light Wand directly toward the shoulder.
Keep the arm relaxed (do not permit the subject to flex his/her
muscles). A relaxed biceps can be achieved by having the subject
seated while resting his arm (elbow bent) on a table.
Use the Light Shield to block the external light. Always avoid
measurements under strong lights (e.g. direct sunlight) because
errors may occur.
CAUTION: Do not move the Light Wand while the decimal point is illuminated. The
actual measurement is being made at that time.
11C) Enter Time Value. Press ENTER.
TIME 4 Over 30 minutes
3 20 - 30 minutes
2 10 - 20 minutes
1 Under 10 minutes
12) Place Light Wand firmly on biceps of the dominant arm (see page 14 for locating exact measurement point).
13) Press ENTER.
The display will flash a decimal point following the number "1". Then the number "2" will be displayed.
14) Remove the Light Wand and replace it on the same point on the biceps.
15) Press ENTER.
The display will flash a decimal point following the number "2".
16) Percent Body Fat is displayed and printed.