Filter
Top Products
Operations Guide 930500E CyberData Corporation
20
Installing the VoIP V3 Indoor Intercom
Adjust the Volume
2.3.5.2 Restoring the Factory Default Settings
When troubleshooting configuration problems, it is sometimes convenient to restore the device to a
known state.
Note Each Intercom is delivered with factory set default values.
To restore the factory default settings:
1. Press and hold the RTFM button (see SW1 in Figure 2-12) for more than five seconds.
2. The device announces that it is restoring the factory default settings.
Note The device will use DHCP to obtain the new IP address (DHCP-assigned address or default
to 10.10.10.10 if a DHCP server is not present).
Figure 2-12. RTFM Button
2.3.6 Adjust the Volume
You can adjust the volume through the Speaker Volume setting on the Device Configuration Page.