Filter
Top Products
Operations Guide 930500E CyberData Corporation
19
Installing the VoIP V3 Indoor Intercom
RTFM Button
2.3.5 RTFM Button
When the Intercom is operational and linked to the network, use the Reset Test Function
Management (RTFM) button (see SW1 in
Figure 2-10) on the Intercom board to announce and
confirm the Intercom’s IP Address and test that the audio is working.
Note You must do these tests prior to final assembly.
Figure 2-10. RTFM Button (SW1)
2.3.5.1 Announcing the IP Address
To announce a device’s current IP address:
1. Press and release the RTFM button (see SW1 in Figure 2-11) within a five second window.
Note The device will use DHCP to obtain the new IP address (DHCP-assigned address or default
to 10.10.10.10 if a DHCP server is not present).
Note Pressing and holding the RTFM button for longer than five seconds will restore the device to
the factory default settings.
Figure 2-11. RTFM Button (SW1)