Filter
Top Products
Advanced Call Handling
Cisco Unified IP Phone User Guide for Cisco Unified Communications Manager 8.6 (SCCP and SIP) 15
Tips
• When calling Mobile Voice Access, you must enter the number you are calling and your PIN if any
of the following are true
:
–
The number you are calling from is not one of your remote destinations.
–
The number is blocked by you or your carrier (shown as “Unknown Number”).
–
The number is not accurately matched in the Unified CM database; for example, if your
number is 510-666-9999, but it is listed as 666-9999 in the database, or your number is
408-999-6666, but it is entered as 1-408-999-6666 in the database.
Connect to Mobile
Vo
ice Access
1. From any phone, dial your assigned Mobile Voice Access number.
2. Enter
the number you are calling from, if prompted, and your PIN.
Turn on Mobile Connect
from your mobile phone
1. Di
al your assigned Mobile Voice access number.
2. Enter yo
ur mobile phone number (if requested) and PIN.
3. Press 2 to enable Mob
ile Connect.
4. C
hoose whether to turn Mobile Connect on for all configured
phones or just one:
–
All phones—Enter 2.
–
One phone—Enter 1, then the remote destination you want to
add, followed by #.
Make a call from your
mobile phone
See P
lacing a Call—Additional Options, page 2.
Turn off Mobile Connect
from your mobile phone
1. Di
al your assigned Mobile Voice Access number.
2. Enter yo
ur mobile phone number (if requested) and PIN.
3. Press 3 to di
sable Mobile Connect.
4. C
hoose whether to turn off Mobile Connect for all configured
phones or just one:
–
All phones—Enter 2.
–
One phone—Enter 1, then the remote destination you want to
add, followed by #.
Turn on or off Mobile
Co
nnect access to all your
remote destinations from
your desk phone
1. Press Mobility to display the current remote destination status
(Enabled or Disabled).
2. Press Se
lect to change the status.
3. Press Exit.
If you want to... Then...