Cisco Systems 7900 IP Phone User Manual


 
43-33
Cisco Unified CallManager System Guide
OL-14153-01
Chapter 43 Cisco Unified IP Phones
Phone Configuration Checklist
Table 43-6 lists the configuration steps for Cisco Unified IP Phones that support SIP. For third-party SIP
phones, see the Third-Party SIP Phone Configuration Checklist in the Cisco Unified CallManager
Administration Guide.
Table 43-6 Phone Configuration Checklist for SIP Protocol
Configuration Steps Procedures and Related Topics
Step 1
Gather the following information about the phone:
Model (7905, 7911, 7912, 7940, 7941, 7960, 7961, 7970,
7971)
MAC address
Physical location of the phone
Cisco Unified CallManager user to associate with the phone
Partition, calling search space, and location information, if
used
Number of lines and associated DNs to assign to the phone
Phone Search, page 43-27
Step 2
If configuring the SIP phone in a secure mode, configure the SIP
Phone Port on the Cisco Unified CallManager Configuration
window.
Cisco Unified CallManager Configuration,
Cisco Unified CallManager Administration
Guide
Step 3
If security is required, complete the SIP Security Profile
Configuration. The SIP Security Profile gets added to the SIP
phone by using the Phone Configuration window.
Phone Security Profile Configuration, Cisco
Unified CallManager Administration Guide
Configuring Cisco Unified IP Phones, Cisco
Unified CallManager Administration Guide
Step 4
Configure the SIP Profile. The SIP Profile gets added to the SIP
phone by using the Phone Configuration window.
Configuring SIP Profiles, Cisco Unified
CallManager Administration Guide
Configuring Cisco Unified IP Phones, Cisco
Unified CallManager Administration Guide
Step 5
If you are using NTP for the timing synchronization, configure
the NTP server by using the Phone NTP Reference Configuration
window. Add the NTP server to Date/Time Group Configuration
and then assign the date/time group to the device pool. Add the
device pool to the SIP phone by using the Phone Configuration
window.
Configuring the Phone NTP References,
Cisco Unified CallManager Administration
Guide
Configuring a Date/Time Group, Cisco
Unified CallManager Administration Guide
Configuring a Device Pool, Cisco Unified
CallManager Administration Guide
Configuring Cisco Unified IP Phones, Cisco
Unified CallManager Administration Guide
Step 6
If you want the digits to be collected before sending them to
Cisco Unified CallManager, configure a SIP Phone Dial plan.
Add the SIP Dial Rule to the SIP phone by using the Phone
Configuration window
Configuring SIP Dial Rules, Cisco Unified
CallManager Administration Guide
Configuring Cisco Unified IP Phones, Cisco
Unified CallManager Administration Guide
Step 7
Add and configure the SIP phone. Configuring Cisco Unified IP Phones, Cisco
Unified CallManager Administration Guide