Filter
Top Products
BaracodaManager for PC – User Guide v3.39 - 25 -
Data Capture
for Workforce
in Motion
7. BL1000 settings
The Settings window displays three buttons and two groups:
- General information
- Shutdown Timers
The following two tables show the General information fields:
Field
Functionality
Radio
Version of Bluetooth chipset
Decoder
Version of embedded Baracoda software
Name
Bluetooth name of the barcode reader
PIN code
The pin code used to authenticate the barcode reader
The following table shows the Shutdown Timer fields that you can set:
Field
Functionality
When connected
Set the delay (in seconds) after which the barcode reader switches off, when
the barcode reader is connected and without any activity.
When disconnected
Set the delay (in minutes) after which the barcode reader switches off, when
the barcode reader is not connected and without any activity.
The table below shows how to use the acknowledgement beep checkbox:
Field
Functionality
Acknowledgement beep
If checked, configure the reader to beep once when the barcode sent to the
host is acknowledged
The table below shows the actions you can take with the buttons:
Button
Functionality
Cancel
Close window with no changes.
Save
Store and send the new parameters to the barcode reader.
Default Settings
Restore the factory settings. The barcode reader (flash) memory is erased and
the factory default parameters are restored. Check the device manual for
details.