Filter
Top Products
Orderable Equipment (continued)
ITEM COMCODE
Handset D-Kit #182835 (white) 107318438
Handset cradle
* 847278603
Thumbscrew
* 847278611
Handset K2G2
* 107244352
Handset cord H4DU * 105635429
PJ327 Adapter
* 407128354
Power module KS22911 L2 405331711
400B2 Adapter 104152558
Power cord (7-foot 2-pronged D6AP87 modular cord) 102937620
* This piece of equipment comes with the Handset D-Kit, but it can also be ordered
separately with the Comcode in the second column.
INSTALLING THE CALLMASTER VOICE TERMINALS
Note: Use the following directions for installing
both
the
CALLMASTER II and the CALLMASTER III voice terminals. The
CALLMASTER voice terminal
cannot
be wall-mounted.
Connecting the Line and Optional Equipment Cords
See Figure 3 for the location of the jacks mentioned below.
1 Lay the voice terminal face down so the bottom slopes toward you.
2 Plug the line cord into the line cord jack. Press firmly until you hear
the line cord click.
3 Press the line cord into the line cord routing channel, placing the cord
under the tab, and gently pull any slack from the cord to the rear of
the voice terminal.
4 Turn the voice terminal rightside up so that the faceplate is facing
you.
5 Plug the line cord into the modular wall jack. (Since the line cord is
7-feet long, your CALLMASTER voice terminal must be within this
distance from the wall jack.)
NOTE: You may also use a 14-foot line cord. To order this cord, see
‘‘Orderable Equipment’’ earlier in these instructions.
10