Filter
Top Products
6
Getting started
Telephone line cord
DSL filter
(Optional for DSL users,
see Note No. 4 below)
NOTES:
1. Use only the provided power cord. If you need a replacement, visit ourvisit our
website at www.telephones.att.com or call 1 (800) 222-call 1 (800) 222-
3111. In Canada dial 1 (866) 288-4268.
2. Be sure to use an electrical outlet not controlled by a wall switch.
3. This power adapter is intended to be correctly oriented in a vertical or floor mount position.This power adapter is intended to be correctly oriented in a vertical or floor mount position.
The prongs are not designed to hold the plug in place if it is plugged into a ceiling, under-
the-table or cabinet outlet.
4. If you receive high speed internet through your telephone line (commonly referred to as DSL) and
you are experiencing interference during telephone conversations and/or your caller ID features
are not functioning properly, install a DSL filter to the telephone line between the telephone base
and the telephone wall jack. Contact your DSL service provider for a DSL filter.
Telephone base and charger installation
4. Plug the large
end of the larger
power adapter into
an electrical outlet
not controlled by a
wall switch.
5. Plug the other end of
the telephone line cord
into a telephone jack.
3. Route cords
through slots.
1. Plug one end of the
telephone line cord
into the telephone jack
at the bottom of the
telephone base.
2. Plug the small
end of the larger
power adapter into
the power jack at
the bottom of the
telephone base.
b. Plug the large end
of the smaller power
adapter into an elec-
trical outlet not
controlled by a wall
switch.
a. Plug the small
end of the smaller
power adapter into
the jack on the
underside of the
charger, then route
the cord through
the slots as shown.
c. The battery
may have enough
charge to allow
for some calls.
For best perform-
ance, place hand-
set in telephone
base or charger
to charge for at
least 16 hours
before first use.