Filter
Top Products
38
Answering system operation
Day & time announcements
To set day & time
Before playing each message, the answering sys-
tem announces the day and time the message
was received.
Before using the answering system, follow the
steps on the left to set the day, time and year,
so messages are dated correctly. If the clock is
not set before playing messages, the system will
prompt "Time and date not set" each time.
The system uses voice prompts to guide you.
Each time you press SKIP or REPEAT, the day,
hour, minute or year increases or decreases by
one. When the correct setting is announced, press
CLOCK to proceed to the next setting.
To check day & time
Press CLOCK anytime to hear the current day and
time without changing it.
NOTES:
1. Press and hold SKIP or REPEAT to increase or
decrease the minute or year by ten.
2. Caller ID provides the time and date. Set the year so that
the day of the week can be calculated from the caller ID
information. After you set the time once, it will thereafter
be set automatically with incoming caller ID information.
The time will be set automatically only if you subscribe to
caller ID service provided by your local telephone company
(page 34).
1.
CLOCK
The system will announce
the current clock setting,
then "To set the clock,
press CLOCK."
2.
CLOCK
3.
SKIP or
REPEAT
4.
until the system announces
the correct hour, then press
CLOCK.
until the system announces
the correct minutes, then
press CLOCK.
until the system announces
the correct day, then press
CLOCK.
5.
6.
until the system announces
the correct year, then press
CLOCK. The system announces
the current clock setting.
The system will announce
the current day setting, then
"To change the day, press
SKIP or REPEAT, to change
the hour, press CLOCK."
SKIP or
REPEAT
SKIP or
REPEAT
SKIP or
REPEAT