Filter
Top Products
24
Telephone operation
Handset settings
Dial type
Using this function, you can choose TONE or PULSE
(rotary) dialing. The factory default setting is TONE.
Change this to PULSE only if you do not have
touch-tone dialing service.
1. Press MENU/SELECT in idle mode to enter the
feature menu.
2. Use up or down NavKey or to scroll to
the DIAL TYPE menu, press MENU/SELECT to
enter the menu when it is highlighted with a >
symbol.
3. Press up or down NavKey or to select
TONE or PULSE.
4. Press MENU/SELECT to save your preference.
5. Press OFF/CLEAR to cancel an operation, back
up to the previous menu, or exit the menu dis-
play. Press and hold OFF/CLEAR to return to
the idle mode.
NOTE: If you have more than one handset registered, dial
type change made on any one handset will apply to all.
Temporary ring silencing
Press OFF/CLEAR or MUTE/DELETE while the tel-
ephone is ringing to silence the ringer temporarily.
This will silence the ringer without disconnecting
the call. The next incoming call will ring normally
at the pre-set volume.
NOTE: If there is more than one handset in use, all hand-
sets ring with an incoming call except those with the vol-
ume turned off. Press OFF/CLEAR or MUTE/DELETE on
one handset will only silence the ringer of that particular
handset but the other handset(s) will continue to ring.
DIAL TYPE
TONE
>
DIRECTORY
CALL LOG
>
DIAL TYPE
DIRECTORY