Filter
Top Products
12
Telephone operation
Basic telephone base operation
Making and answering calls
To answer an incoming call, press SPEAKER, or
any dial pad key (0-9, * or #). To make a call, press
SPEAKER, then dial a number. Press SPEAKER
again to hang up.
Last number redial
When the telephone base is idle, pressing REDIAL/PAUSE
will activate the speakerphone and dial the most
recently called number (up to 32 digits).
NOTES:
1. After pressing SPEAKER on the telephone base, if you press
and hold REDIAL/PAUSE while dialing, it will insert a three-sec-
ond dialing pause.
2. If you dial a number after pressing FLASH, that number will
not be saved in redial. The next time you use REDIAL/PAUSE
from the base, it will dial the number that was called before
the FLASH was pressed.
Handset locator
If you misplace the handset(s), press
HANDSET LOCATOR/INTERCOM on the telephone
base. This starts the paging tone on the handset(s)
for 60 seconds to help you locate the handset(s).
To stop the paging tone, press PHONE/FLASH,
SPEAKER, or any dial pad key (0-9, * or #) on the
handset(s), or press HANDSET LOCATOR/INTERCOM
on the telephone base.
Speakerphone
NOTES:
1. The handset ringer volume
also determines the volume
of the paging tone. If the
handset ringer volume level
is set to off (0), that handset
will be silent for all incoming
calls and paging (page 20).
2. During a page, if you press
OFF/CLEAR on a handset,
the ringer of that handset
will be silenced, but the
page will not be cancelled.