Filter
Top Products
46
Screen is Flashing
Unplug the power cord for 10 seconds,then plug it back in.
Screen Continues to Display LIFT RECEIVER
When you’re using the Display Dial feature,if the screen continues to display LIFT
RECEIVER even after you’ve lifted the handset of the attached phone,check the line cord
installation. Make sure the line cord from the telephone is inserted into the correct jack
on the system, and the line cord from the modular wall jack is inserted in the jack labeled
L1/L2 on the system.
Some of the Message is Not Audible
If Caller ID information is received while the unit is recording a message, up to one
second of the message might not be audible.
Display Dial Doesn’t Work
• Check to make sure you have followed the instructions for “Home Area Code”and
“Local Area Code” guidelines.
• When you use the Display Dial feature, you will not hear the number being dialed.
Memory is Full
When recording a two-way conversation, you must press P or use the softkey to
select STOP
to stop recording;otherwise, all available memory will be used. Hanging up
the phone does not stop two-way recording.
Screen Display is in Wrong Language
Follow the directions on page 22 to set display screen language.
IN CASE OF DIFFICULTY
1782_book_1AT&T 5/1/00 7:35 PM Page 46