Filter
Top Products
17
Priority Call Signal for the System
When a caller enters the Priority Call Code from a touch tone phone,the system beeps
loudly to alert you that you have a Priority Call. You’ll need to provide select callers with
the Priority Call Code (preset to 999),in order for them to use this feature. The Priority
Call Code is the same for both lines and is set using Line 1.
1 Your caller dials your telephone number from a touch tone phone.
2 When the announcement begins to play, your caller enters the Priority Call Code.
3 The system beeps three times,then pauses. This continues for up to 30 seconds,
unless you answer the phone.
4 If you do not answer,your caller can press 5 to stop the Priority Call signal and
leave a message.
Change Priority Call Code for the System
The Priority Call Code comes set to 999,but you can change it to any three-digit number
from 100 to 999. Do not set the Priority Call Code to the same number as the Remote
Access Code.
1 Press o.
2 Use the softkey to select ANS
SYS. The screen displays Set options for which
mailbox?
3 Use the softkey to select L1
. The screen displays your choice.
4 Select OK
until the screen displays Priority Call Code.
5 Press C or c to change the first digit.
6 Select NEXT
to move to the second digit.
7 Press C or c to change the second digit.
8 Select NEXT
to move to the third digit.
9 Press C or c to change the third digit.
10 Select OK
.
SET UP SYSTEM FEATURES
1782_book_1AT&T 5/1/00 7:35 PM Page 17