Filter
Top Products
19
Caller ID Feature Setup
Turn Caller ID with Call Waiting On or Off for a Line
If you don’t want to be disturbed with call information about Call Waiting calls,you can
turn this feature off.
NOTE: This is the only Caller ID feature you can set up separately for each line.
1 Press o.
2 Press C.
3 Use the softkey to select CALL ID
. The screen displays L1-Caller ID with
Call Waiting.
4 Select CHANGE
or press C or c to turn the feature On or Off.
5 Select OK
.
6 Repeat Steps 4 and 5 to set Caller ID with Call Waiting for Line 2.
Turn Incoming Number Announce On or Off
If you want the system to announce the line and phone number of the caller when you
receive a call,you can turn this feature on (it is preset to off).
1 Press o.
2 Press C.
3 Use the softkey to select CALL ID
. Select OK until the screen displays Local
Number Announce: Off.
4 Select CHANGE
or press C or c to turn the feature On or Off.
5 Select OK
.
Program Area Codes
You must program Home and Local Area codes into the system to allow it to properly
recognize and dial calls from the Caller ID call history (when using the Display Dial
feature). When you program these specific area codes,the system can distinguish a local
call from a long distance call, so it can dial the appropriate number of digits.
SET UP SYSTEM FEATURES
1782_book_1AT&T 5/1/00 7:35 PM Page 19