Filter
Top Products
/ IP Phone User Guide 23
Handling Calls from the 480i CT Base Station
You can configure a Park and
Pickup programmable
configuration using the Aastra
Web UI.
Programmable Configuration Using
the Aastra Web UI
On the 480i CT, you configure a
Park and/or Pickup key at
Operation->Softkeys and XML.
You enter a key label, and value for
a specific line on the phone. The
default state of the Park
configuration is "connected". The
default state of the Pickup
configuration is "idle, outgoing".
The 480i CT handsets use the park/
pickup configuration enabled at
Operation->Handset Keys in the
Aastra Web UI. If Park or Pickup
are enabled on more than one line
on the base unit, the 480i CT
handset uses the first
programmable configuration.
For example, if line 1 and line 6 are
configured for park, the 480i CT
handset uses the configuration set
for line 1 to park a call.
Note: Applicable values depend on the
server in your network (Asterisk,
BroadWorks, Sylantro, ININ
PBX. See the table "Park/Pickup
Call Server Configuration Val-
ues" on page 21.
Configuring Park/Pickup of
Programmable Configuration
Use the following procedure to
configure the Park/Pickup call
feature using the programmable
configuration method.
1. Click on Operation->
Softkeys and XML.
2. Pick a softkey to configure for
Parking a call.
3. In the "Type" field, select Park.
4. In the "Label" field, enter a label
for the Park softkey.
5. In the "Value" field, enter the
approriate value based on the
server in your network.
Note: For values to enter in this field,
see the table "Park/Pickup Call
Server Configuration Values" on
page 21.
6. In the "Line" field, select a line
for which to apply the Park con-
figuration.
7. Pick a softkey to configure for
Picking up a call.
8. In the "Label" field, enter a label
for the Pickup softkey.
9. In the "Value" field, enter the
approriate value based on the
server in your network.
Note: For values to enter in this field,
see the table "Park/Pickup Call
Server Configuration Values" on
page 21.
Aastra Web UI