Filter
Top Products
92 CHAPTER 2: INSTALLATION SCRIPTS
End of IP Conferencing Module Configuration
Sample vcx-setup
Script (Conference
server)
This section contains a sample of the vcx-setup script for the conference
servers in a multiple server configuration that has between four and
twelve servers.
In a multiple server configuration, up to ten servers can host conferences.
Two others (the primary and secondary servers) must be dedicated to
hosting the redundant database.
The following options are selected in this sample script:
n Conferencing server configuration (conference server and conference
attendant server)
To run the vcx-setup script:
1 Log in to the server as root.
2 Enter a password (default is pvadmin).
3 Press Enter (or Return).
-bash-2.05b# vcx-setup
Enter vcx-setup at the command prompt.
---------------------------------------------------------------------------
---------- Welcome to the VCX Linux Network Configuration Wizard ----------
---------------------------------------------------------------------------
This wizard sets up networking and related services.
Start of Network Configuration
Configure networking now? [yes] :
Press the Enter or Return key to accept yes as the suggested answer.
--------- Configuring Dynamic Host Configuration Protocol (DHCP) ----------
VCX servers can use DHCP for automated configuration, but this requires
that the DHCP server is configured to provide the proper options. Unless
you know that your environment is set up in this way, you should say 'no'
here and configure static network parameters.
Use DHCP on eth0 to configure network parameters? [no] :
---------- Configuring Hostname ----------
Enter system hostname [localhost] : conf.yourcompany.com