Filter
Top Products
Single Server Initial Installation 23
Enter vcx-setup at the command prompt.
---------------------------------------------------------------------------
---------- Welcome to the VCX Linux Network Configuration Wizard ----------
---------------------------------------------------------------------------
This wizard sets up networking and related services.
Start of Network Configuration
Configure networking now? [yes] :
Press the Enter or Return key to accept yes as the suggested answer.
--------- Configuring Dynamic Host Configuration Protocol (DHCP) ----------
VCX servers can use DHCP for automated configuration, but this requires
that the DHCP server is configured to provide the proper options. Unless
you know that your environment is set up in this way, you should say 'no'
here and configure static network parameters.
Use DHCP on eth0 to configure network parameters? [no] :
---------- Configuring Hostname ----------
Enter system hostname [localhost] : conf01.yourcompany.com
---------- Configuring IP Interface 'eth0' ----------
Enter IP Address [192.168.1.100 ] : 10.20.30.60
Enter Network Subnet Mask [255.255.255.0 ] : 255.255.255.0
Enter Default Gateway Address [10.20.30.254 ] : 10.20.30.254
---------- Configuring IP Interface 'eth1' ----------
Interface State : disabled
Note that ‘eth1’ is not used for the 3Com IP Conferencing Module.
---------- Configuring DNS Servers ----------
Enter DNS servers one at a time.
When done, enter 0.0.0.0 to stop.
Primary DNS Server [192.168.1.1] : 10.25.10.31
Secondary DNS Server [192.168.1.2] : 10.26.10.31
Tertiary DNS Server [0.0.0.0] : 0.0.0.0
---------- Configuring DNS Search Path ----------
Press Enter to leave the current path unchanged, or specify
a new search path, with spaces separating each entry.
DNS Search Path []: yourcompany.com