Filter
Top Products
108 CHAPTER 2: INSTALLATION SCRIPTS
1 (ACTIVE)
2 (NOT_IN_SERVICE)
3 (NOT_READY)
4 (CREATE_AND_GO)
5 (CREATE_AND_WAIT)
6 (DESTROY)
cct
-Index -RowStatus -TrustedAddress -Netmask
2 1 10.1.0.157 255.255.255.255
3 1 10.1.1.8 255.255.255.255
5 1 10.1.0.3 255.255.255.255
6 1 10.1.4.1 255.255.255.255
7 1 10.1.1.240 255.255.255.255
8 1 10.1.0.239 255.255.255.255
9 1 10.1.1.1 255.255.255.255
6 To exit the remoteCli application, enter
exit
For information on how to program trusted endpoints on the VCX, see
the 3Com VCX Administration Guide.
Test E-Mail
Notification
Setup
Run the following test to ensure that the e-mail setup works correctly.
1 Log in to the server as root.
2 At the prompt, enter:
/usr/sbin/sendmail user@domain.com
From: sender@domain.com
To: user@domain.com
Subject: test e-mail
[blank line]
test1
test1
test1
3 Ctrl-D
Be aware that most Mail Transfer Agents (MTAs) require valid To: and
From: addresses.
If the user fails to receive the e-mail message, check for errors in
/opt/logs/vcx-linux/maillog. After resolving the problem, run
the E-Mail setup again.