Filter
Top Products
UIP200 User's Manual
Page 20 of 27
Rev. 1.0, © UAC, May, 2004
Feature Operations
Programmable and Fixed Function Keys
There are eight programmable function keys and eight fixed functions keys in the
UIP200. Programmable function keys can be assigned to any one of the available
functions: One-touch speed dial, Two-touch speed dial, DND, Voice Message
Access (VMA) or Mute. The programmable keys also act as LEDs to indicate the
status of the assigned function.
Table 4 Fixed-Function Key and Programmable Key Defaults
Key Operation
Programmable key 1-4 One-Touch Dialing
Programmable key 5 Two-Touch Dialing
Programmable key 6 Do Not Disturb
Programmable key 7 Voice Message Access
Programmable key 8 Mute (microphone)
1-Touch Dialing
Programmable Keys 1 through 4 come pre-programmed with 1-Touch dialing
feature. To use the 1-Touch dialing feature, you must program a phone number to
one of the 1-touch programmable keys (see Programming a 1-Touch Number on
page 23). (1-Touch dialing keys do not illuminate to indicate their state).
1-Touch Dialing–Off-Hook Operation
Step 1: Pick up the cradle or press the HEADSET/SPEAKER key.
Step 2: Select the appropriate 1-
TOUCH key. If you programmed the DIAL key as part of
the number, the phone will start connecting immediately; otherwise, connection
will start the after approximately 4 seconds.
1-Touch Dialing–On-Hook Operation
Step 1: Press the desired 1-TOUCH key.
Step 2: Pick up the cradle or press the
HEADSET/SPEAKER key. If you programmed the
DIAL key as part of the number, the phone will start connecting immediately;
otherwise, connection will start the after approximately 4 seconds.