Filter
Top Products
UIP200 User's Manual
Page 12 of 27
Rev. 1.0, © UAC, May, 2004
Function Keys
There are eight user programmable function keys in the UIP200. Each can be
programmed to one of several functions, for example, 1-Touch Speed Dialing,
Voice Message Access, Do Not Disturb, Mute, or 2-Touch Speed Dialing.
LED Status
There are eleven LEDs on the UIP200 IP phone. Two LEDs are also the fixed-
function keys HOLD and HEADSET/SPEAKER. These fixed-function keys illuminate
to show the status of the function while it is used. Another LED, the Visual Ringer
LED, notifies the user of an incoming call. The other eight LEDs are the
programmable function keys; these keys illuminate when they are used.
Table 3 LEDs and Their Meanings
LED LED On LED Blinking LED Off
All LEDs The phone has powered
up and is initializing.
N/A The phone has
initialized.
HOLD
N/A A call is on hold. N/A
HEADSET/SPEAKER
The speaker phone or
headset is enabled.
N/A The speaker phone or
headset is disabled.
MUTE
(programmable
button)
The mute function is
enabled.
N/A The mute function is
disabled.
DND
(programmable
button)
Do Not Disturb mode is
enabled.
N/A Do Not Disturb mode
is enabled.
VISUAL RINGER
A voice message is
waiting.
There is an
incoming call.
N/A
! NOTE
If all 8 programmable keys remain illuminated, refer to
Appendix A for troubleshooting steps.
Specifications
The following specifications apply to the physical interface, power supply, and
speaker.