Filter
Top Products
56
Inuse Line Setup (Base only)
The Inuse Line Setup feature is only used in instances where you have multiple phones where users may pick up an
extension while someone else is on the phone. Only in very rare instances where your phone system is not detecting
that an extension phone is picked up will you ever need to change this feature. In most all situations, this feature will
never need to be used or modied from the factory default setting of TYPE-A. There are three settings for this fea-
ture: TYPE-A, TYPE-B, or OFF.
You should only change this option when instructed to by customer service and when you are experiencing one of
the following issues:
Issue Problem Resolution
When using an extension phone,
“Line in Use” will not appear in the
original handset display.
Your phone should detect when an
-
other extension phone is used.
Set the Inuse Line Setup to “TYPE-
B” or contact Uniden’s customer ser
-
vice hotline. See back cover pag
e
for contact information.
You place a caller on hold. You pick
up an extension handset and nish
your conversation. You hang up the
call from your extension handset,
but the original station where you
placed the caller on hold does not
release the line and therefore, thinks
you still have a party on hold.
Your phone system is not detecting
that the line was picked up and re
-
leased.
Contact Uniden’s customer service
hotline. See back cover pag
e for
contact information.
Note: Do not set your Inuse Line Setup to OFF unless instructed to by a Uniden Customer Service Representative. If
you set the Inuse Line Setup to OFF, your phone cannot detect the status of an extension phone while in use and will
not operate correctly.