Filter
Top Products
TROUBLESHOOTING[ 62 ]
Symptom Suggestion
The Caller ID does not display. • The handset was picked up before the second ring.
• The call was placed through a switchboard.
• Call your local telephone company to verify your Caller ID service is current.
• Charge the handset.
The handset doesn’t communicate •Change the digital security code (See page 57).
with the base or the other handset. •Make sure that you have registered the second handset (TXC580 only).
“
Unavailable” message is • Make sure the other handset is not already in use. Both handsets cannot be
displayed on the LCD screen of in talk mode at the same time.
the handset. • Place the handset for at least 5 seconds to re-register to the main base.
• Make sure the handset is not too far from the main base when trying to use.
The second handset can’t join • Only one handset at a time can talk with an outside caller. To allow a different
the conversation. handset to talk to the caller, transfer the call to the other handset.
The answering system does not work. •Make sure the base unit is plugged in.
• Make sure that the answering system is turned on.
• Make sure that the message record time is not set to Announce only
(See page 45).
Messages are incomplete. • The incoming messages may be too long. Remind callers to leave a brief message.
• The memory may be full. Delete some or all of the saved messages.
After a power failure, the outgoing •Record your greeting again. The default message should remain.
message is deleted.
No sound on the base unit • Adjust the speaker volume on the base unit.
speaker during call monitoring
or message playback.
Cannot access remote call-in features •Make sure you are using the correct PIN number.
from another touch-tone phone. • Make sure that the touch-tone phone you’re using can transmit the tone
for at least two seconds. If it cannot, you may have to use another phone to
access your message
If you still have a problem. •Call our customer hotline at 1-800-297-1023.