Filter
Top Products
[ 22 ]
Tone Dialing Switch-over
Some telephone companies use equipment that requires pulse dialing
(sometimes referred to as rotary dialing). If you need to enter tone dialing
digits, you can switch-over to tone dialing during the call. For example,
entering your bank account number after you have called your bank.
Initially make your call with the pulse dialing mode. Once your call
connects, press
/tone. Enter the desired number. These digits will be
sent as tone dialing. Once the call ends, the tone mode is canceled and
pulse dialing mode resumes.
• The tone feature only
applies when the dial
mode is set to pulse.
• This special number can
be stored in a memory
location. This is referred
to as Chain Dialing. (See
page 34.)
BASICS
• If you press end to
cancel muting, the call
is disconnected and the
phone will return to
standby mode.
• If you press
xfer/del
on the handset or
find handset/transfer
or flash on the base
while muting, the
muting is canceled.
Mute Microphone
You can temporarily turn Off the microphone so that the person you are
talking with cannot hear you.
With the handset
During a telephone call press and hold menu/mute to turn Off the
microphone, and “
Mute” appears on the display. Press menu/mute
again to cancel muting.
With the base
During a telephone call press mute on the base to turn Off the
microphone.
Speaker LED on the base flashes. Press mute again, or
press (talk) to cancel muting.
Traveling Out-of-Range
During a call, as you begin to move your handset too far from your base unit, noise increases.
If you pass the range limits of the base unit, your call will terminate within 30 seconds.