Filter
Top Products
PHONEBOOK[ 34 ]
Chain Dialing
The memory locations in the handset are not limited to phone numbers. You can also
store a group of numbers (up to 20 digits), that you need to enter once your call
connects. This is referred to as Chain Dialing.
An example of this is a bank account number. Store the special number in the Phonebook
location (refer to “Storing Phone Numbers, Names, Distinctive Rings and Speed Dial” on
page 26). Once you have called your bank, and when you are prompted to enter the
account number, press
/RocketDial/
and use + or - to select the number in the
Phonebook location, then press select/ch.
Memory Dialing (base only)
You can store 10 phone numbers in the base, and make calls with memory dialing from the base.
Storing Phone Numbers
1) Press memory in the standby mode.
2) Enter the number you wish to store. (The number cannot exceed 20 digits.)
3) Press
memory. Enter the memory location number (0-9) on the keypad.
You will hear a confirmation tone.
Making Calls with Memory Dialing
1) Press (talk) in the standby mode.
2) Press
memory. Enter the memory location number (0-9) to dial the number.
Deleting the Stored Data
1) Press memory in the standby mode.
2) Press
memory again.
3) Enter the memory location number (
0-9) you wish to delete. You will hear a confirmation tone.
• The 10 memory locations in the base are independent from the handset.
• The pause key counts as one digit. Pressing
redial/p more than once increases the length of
pause between numbers.
• If you have not pressed
any key for 30 seconds,
the phone returns to the
standby mode.
• If you get an incoming
call, the operation
is canceled.
• If you select a memory
location that does not
have a stored number,
the base will beep
rapidly and the phone
will not dial.