Filter
Top Products
19
TRANSMITTING
The POLARIS transmits on fifty-five marine frequencies and
receives on eighty marine frequencies. Channel 70 of the USA,
International, and Canadian frequencies, and channel 15, of the USA
frequencies, and WX CH – are for receiving only. The POLARIS
transmits on channel 70 when sending DSC information. Your radio will
not transmit on these channels. For your reference, a listing of all the
available marine channels are located on pages 67 - 69.
SETTING TX OUTPUT
Caution: It is important to remember to use the LO position in port or
for short range communications.
1. When you turn the POLARIS On for
the first time, the unit is automatically
set to transmit at 25 watts (HI).
2. Press
H/L/MENU to change the
transmitter output to 1 watt (LO).
3. Press
H/L/MENU again to change
back to 25 watts (HI).
Note: Each time the H/L/MENU is pressed a short tone sounds.
CH13 is set as 1 watt (LO) channel. When the channel is set
as LO power channel, you can transmit at 25 watts (HI) by
pressing and holding H/L/MENU during the call.
LO power channels are 13 and 67 for USA, and 13, 15, 17,
and 20 for CAN.
HI USA
DISTRESS
LO USA
DISTRESS
HI USA
DISTRESS
POLARIS_UT888ZL_UT01888ZA_0 10/3/02 4:18 PM Page 19