Uniden DCT7488 Cordless Telephone User Manual


 
THE INTEGRATED ANSWERING DEVICE [66]
www.uniden.com
Voice memo
The voice memo function allows the user to record messages (more than two
seconds and less than four minutes).
1) With the phone in standby mode, press the RECORD soft key on the base.
2) Press the START soft key. You will hear the announcement "Record Memo
Message" and a confirmation tone.
3) Start your recording.
4) When you have finished, press the STOP soft key to stop recording. The system
returns to standby.
•The voice memo messages are recorded as an incoming messages.
•When the answering system is full, appears on the display, and recording is
terminated.
Recording a conversation
You can record a conversation from the handset or the base (more than two seconds
and less than ten minutes).
1) During a conversation, press menu/clear (or the MENU soft key on the base).
2) Press volume up/down to select
Call Record
, and then press select/ /audio
tone (or the OK soft key on the base).
Recording a Call
appears on the display.
A confirmation tone that can be heard by both parties sounds during recording.
Use the same procedure to stop recording.
Stop Recording
appears.
Screening a call
From the base
To screen an incoming call, use the following steps:
(7..
•If the recording
memory is full,
Unavailable
appears
in the display. You can
not record a
conversation until you
clear some messages
from the memory.
•Every state has
different regulations
governing the
recording of
conversations over the
telephone. Make sure
to check your local,
state and federal laws
before using this
product to record any
telephone
conversation in order
to determine that your
use is in compliance
with such laws or
guidelines.
•You can not record
intercom
conversations.
•To activate this
feature, you must turn
the Call Screen feature
on. See “Setting the
Call Screen“ on
page 60.
note
THE INTEGRATED
ANSWERING DEVICE