Filter
Top Products
[17] GETTING STARTED
www.uniden.com
Register the Handset
If you purchase an expansion handset, you need to register the handset before use.
Only one handset can be registered at a time.
Handsets supplied with the phone are registered to the base by the factory. When
charged, pre-registered handsets display a handset ID number. Handsets that have
not been registered display
Models vary! Charge handset on the base for
registration or refer to Owner's Manual.
When you register an extra handset to
the base, the handset ID will be assigned.
1) Before registering the extra handset, the battery pack MUST be charged for 15-20
hours.
2) With the main base in standby mode, press the MENU soft key on the base.
3) Press /volume up/down on the base to select HS Registering, and then press
the
OK soft key.
4) On the handset, press and hold #/> for two seconds. To cancel registration, press
the
CANCEL soft key on the base.
5) While the handset is registering,
Handset Registering
will appear in the LCD.
When
Registration Complete
is displayed, the handset has been registered to the
base. If
Registration Failed
appears, please try these steps again.
The DCX640 expansion handset (DCT7 series-compatible model) can be registered to
the base by following the same steps above.
Your phone may be
compatible with other
Uniden 2.4GHz Digital
Expandable Systems.
Please visit our
website at
www.uniden.com for
model number
confirmation or call
our customer service at
(800) 297-1023.
note
GETTING STARTED