Uniden TRU 8866 Cordless Telephone User Manual


 
SETTING UP THE PHONEBOOK [44]
www.uniden.com
Storing Caller ID messages in the Phonebook
Messages shown in the Caller ID list can be stored in the phonebook (see page 51).
The phone number and name of the party on the Caller ID list can be stored in
memory.
1) When the phone is in standby mode, select the Caller ID message to be stored.
2) Press the
EDIT soft key. Press volume up/down to select
Store into PB?
, and then
press the OK soft key.
3)
Store/Edit Name
appears.
If the Caller ID message is already stored in memory, you will hear a beep and
This data is already stored!!
appears. The number will not be stored.
4) To complete the setting, follow the steps 4-8 in “Storing and Editing Phone
Numbers, Names, Distinctive Rings and Speed Dial” on page 41.
Storing a Redial Record
1)With the phone in standby mode, press redial/p (or redial/pause on the base) in
standby mode.
2) Press volume up/down repeatedly to display the number to be stored.
3) Press the EDIT soft key.
4) Press volume up/down to choose
Store into PB?
, and
then press the OK soft key.
5) To complete the setting, follow the steps 3-8 in
“Storing and Editing Phone Numbers, Names,
Distinctive Rings and Speed Dial” on page 41.
•If a call comes in via a
telephone system that
does not offer Caller ID
service, no information
is stored.
•If the Caller ID
message was received
as a private/unknown
number, or the
message does not have
the number, you
cannot store the
message in the
Phonebook. If it was
received as private/
unknown name, the
message will be stored
as <No Name>.
•Even if all 100 memory
locations are full, the
message will be stored
in the Phonebook.
However, the message
will be erased from the
Caller ID list.
note
SETTING UP THE
PHONEBOOK
UP772.book Page 44 Monday, August 29, 2005 1:15 PM