ADDITIONAL INFORMATION
[ 35 ]
ADDITIONAL
INFORMATION
SSyymmppttoomm
The answering system does
not work.
Messages are incomplete.
After a power failure, the
outgoing message is deleted.
No sounds on the base unit
speaker during call monitoring
or message playback.
Cannot access remote call-in
features from another touch-
tone phone.
SSuuggggeessttiioonn
• Make sure the base unit is plugged in.
• Make sure that the answering system is turned on.
• Make sure that the message record time is not set to
AANNNN
(See page 25).
• The incoming messages may be too long. Remind callers to leave a brief
message.
• The memory may be full. Delete some or all of the saved messages.
• Record your greeting again.
The preset messages should remain.
• Adjust the speaker volume on the base unit.
• Make sure you are using the correct PIN number.
• Make sure that the touch-tone phone you´re using can transmit the
tone for at least two seconds. If it cannot, you may have to use another
phone to access your message.
TRU3455 ENG 6/28/01 11:28 AM Page 35