3
Test the Connection
Pick up the corded handset from the base. You should hear a dial tone
and the display on the base should say
Talk
. When you get a dial tone,
make a quick test call.
If... Try...
the display says
Check Tel Line
or you don't hear a dial tone
checking the connection between the
base and the phone jack.
you keep hearing a dial tone changing to pulse dialing (see below).
there's a lot of noise or static
see page 28 for tips on avoiding
interference.
Changing from Tone to Pulse Dialing
Phones can communicate with the telephone network in two different
ways: tone (DTMF) or pulse dialing. If you know your phone company uses
pulse dialing or you can't make your test call, follow these steps:
With the phone in standby, press
SELECT/MENU
.
Use
UP
or
DOWN
to highlight
Global Setup
, then press
SELECT/MENU
.
Use
UP
or
DOWN
to highlight
Dial mode
, then press
SELECT/MENU
.
Highlight
Pulse
, then press
SELECT/MENU
. The phone sounds a
confirmation tone. Try making another test call.
If you use pulse dialing and you need to send DTMF tones during a call (if
you're using an automated response system, for example), press to
temporarily switch to tone dialing. When the call ends, the phone
automatically returns to pulse dialing mode.
Set Up the Accessory Handset(s)
If your phone came packaged with accessory handsets, follow the steps
below to get your cordless handsets ready for use.
Install the battery
Unpack all handsets, battery packs,
and battery covers. If any
handset has the battery
cover already attached,
press in on the notch and
slide the cover down and
off.
1)
2)
3)
4)
1)