Filter
Top Products
GETTING STARTED
GETTING STARTED [ 9]www.uniden.com
B. Install the rechargeable battery packs into both handsets
Both handsets are powered by rechargeable battery packs.
The battery recharges automatically when the handset is placed
in the base unit or charging cradle.
Charge the handset battery packs for at least 15-20 hours
before using your new cordless telephone for the first
time!
To maximize the charge capacity of your battery pack,
DO NOT plug the telephone cord into the base unit and wall
jack until the battery is fully charged.
1) Press down on the handset battery case cover (use the
finger indention for a better grip) and slide the cover
downward to remove.
2) Plug the battery pack connector (red & black wires) into the
small jack inside the battery compartment. (The connector
notches fit into the grooves of the jack only one-way.) Match
the wire colors to the polarity label in the battery
compartment, connect the battery and listen for a click to
insure connection.
3) Make sure you have a good connection by slightly pulling on
the battery wires. If the connection is secure, the battery jack
will remain in place.
• Use only the
Uniden (BT-905)
rechargeable battery
pack supplied
with your
cordless telephone.
• Replacement batteries
are also available
through the Uniden
Parts Department at
(800) 554-3988,
Monday through Friday
from 8:00 a.m. to 5:00
p.m. or on line at
www.uniden.com
• Place the second
handset in the charger
with the keypad facing
forward for 15-20
hours before use.