GETTING STARTED[ 12 ] www.uniden.com
• Place the power cord
so that it does not
create a trip hazard
or where it could
become chafed and
create a fire or
electrical hazard.
•
Use only the supplied
AD-0001 AC adapter.
Do not use any other
AC adapter.
• Connect the AC adapter to a continuous power supply.
• Place the base unit and charging cradle close to the AC
outlets so that you can unplug the AC adapters easily.
C. Connect the base unit and charging cradle
1) Connect each AC adapter to the DC IN 9V jack
and to each standard 120V AC wall outlet.
2) Set the base and charging cradle on a desk or
tabletop, and place one handset in the base unit
and one in the charging cradle.
3) Raise the base antenna to a vertical position.
4) Make sure that the
charge/in use and charge LED
illuminate. If the LED does not illuminate, check
to see that the AC adapter is plugged in and that the handset makes good contact
with the cradle’s charging contacts.
Route the cord.
After installing the battery packs in the handsets, charge your handsets at least 15-20
hours before plugging into the phone line
.
5) Once the handset battery packs are fully charged,
connect the telephone line cord to the
TEL LINE
jack and to a telephone outlet.
Modular
If your telephone outlet isn't modular,
contact your telephone company
for assistance.
Place the handset in
the base or charging
cradle with the
keypad facing
forward for charging.