GETTING STARTED
GETTING STARTED [ 19]www.uniden.com
1) When the phone is in the standby mode, press and hold the
cid/menu key. The following screen appears.
2) Press the
vol/ring/ key to select “Dial”.
3) Press the
select/channel key to toggle between “Tone” and
“
Pulse”.
4) Press the
end key and return the handset to the base unit to complete the setting.
The handset returns to standby mode.
Setting the language
1) When the phone is in standby mode, press and hold the
cid/menu key. The following screen appears.
2) Press the
vol/ring/ key to select “Language”.
3) Press the
select/channel key to toggle between “Eng”, “Fr.”
and “
Esp”.
4) Press the
end key or return the handset to the base unit or charging cradle to
complete the setting. The handset returns to standby mode.
• Dialing mode can only
be changed from
handset 1. To confirm
which handset is HS1,
look at the display
indicating “HS1” or
“HS2”.
• If you are not sure of
your dialing system,
set for tone dialing.
Make a trial call. If the
call connects, leave the
setting as is, otherwise
set for pulse dialing.
• If your phone system
requires pulse dialing
and you need to send
the DTMF tones for
certain situations
during a call, you may
"switch over" to tone
dialing. (Refer to "Tone
Dialing Switch over" on
page 22.)