Filter
Top Products
SoftIPT
Configuring SoftIPT 3.0
Strata CIX IP5000-series Telephone UG 07/09 35
2. In the SoftIPT Configuration window, enter the following:
Fields Description
Phone No. This is the SoftIPT extension.
Password Password for IP user mobility
Node The node ID where the MIPU resides. By default, leave blank.
Outgoing prefix When a call is made using the SoftIPT directory, SoftIPT
automatically attaches the outgoing prefix for local calls, or long-
distance prefix for long-distance calls, respectively. See
“Using the
Directory” on page 41 for details.
Long distance prefix
IP address of IPU
SoftIPT tries to connect to the IPU using the following addresses
in turn:
• Primary IPU IP address
• Secondary IPU IP address.
Notes
If Broadcast is selected, SoftIPT tries to search for the IPU by
sending broadcast messages, otherwise, it goes back to the
Primary IPU IP address. SoftIPT skips the Primary IPU IP address
or the Secondary one if it is not set. In either case, if SoftIPT
successfully connects to the IPU, the IPU IP address is shown in
the “Connected IPU IP Address” field. See your System
Administrator for IPU address.
If Broadcast is selected, the broadcast message is sent on the
same subnet, which means SoftIPT can connect to the IPU on the
same subnet using Broadcast mode without designating the IPU
IP address. However, in some PC environments, SoftIPT cannot
complete this broadcast registration sequence because the lower
network module does not notify SoftIPT, through Windows, of
receiving a reply message after sending a broadcast message.
Therefore, Toshiba recommends using Manual mode if SoftIPT
cannot find the IPU by Broadcast.
Network If there are multiple network adapters, select the one for SoftIPT.