Filter
Top Products
136
Strata CT Digital Telephone User Guide November 2001
Message Waiting Single Line Digital Telephone Features
Retrieve a Call on Exclusive Hold
Message Waiting
If your station is idle or busy on a call while another station tries to contact you, the calling station can
turn on the message waiting LED on your telephone. Your Message Waiting lamp flashes when there
is a message.
When you respond by pressing
Msg
MsgMsg
Msg
, you will either hear a voice message or your phone will dial the
telephone which set a callback message. Voice mail devices and stations can leave message waiting
indications.
Up to four Message Waiting indications can be left at a station at one time. One of the indications is
for the Message Centre.
➤
To answer a Message Waiting light
➤ Press
Line
again. If a call is not retrieved by a certain time (set in system
programming), it recalls back to your phone. You hear
repeated recall tone (or if you are on the phone, you hear
recall tone twice).
If the held party hangs up, the call is released and the
Exchange provides a hold-release signal.
1. Lift the handset and press
Msg.
You hear dial tone after lifting the handset.
Your phone rings the device that set the indication. If there is
no answer, hang up and try later. (The LED continues to
flash.)
...or lift the handset and press
Line
+
#408
.
2. If your telephone calls a busy
station or there is no answer, hang
up and try later.
The LED continues to flash.
...or you can bypass this message
and listen to the next message by
going on-hook and repeating Steps
1 and 2.