Filter
Top Products
The Grand Tour
Buttons
Strata DK Digital Telephone 6/00 5
+ROG(continued)
If the held party hangs up, the call is released and the CO provides a hold-
release signal.
If your telephone is programmed for Automatic Hold, existing calls are
automatically placed on hold when you answer a call or make another call. (See
“Automatic Hold” on Page 26.)
A different call can be held on each [DN] or
/LQH button on your phone. Each time you
press 6FUROO, a different [DN] or /LQH is
selected. The selected button’s LED flashes
rapidly and your LCD displays information for
the call holding on that button (samples shown
at right).
0LF
(Microphone)
Press to toggle the microphone ON/OFF while the telephone is in use. The LED
indicates the status of the microphone.
The microphone and accompanying LED are always ON when receiving “voice
first” internal [DN] calls to enable Handsfree Answerback and OFF if you receive
a ring-first call. Mic may be ON/OFF when placing an on-hook CO line or
internal [DN] call.
Each station’s Mic can be set in system programming to switch ON/OFF with
one touch, to switch OFF only while pressed and held, or to be either ON/OFF
at the start of handsfree dialing.
To talkback to an HS-OCA call, press and hold Mic and talk over your telephone
handset/headset. The LED and microphone remain OFF during OCA talkback
operation (see “HS-OCA” on Page 62).
Mic functions on Handsfree Answerback and OCA calls for privacy.
0VJ
(Message)
When Msg LED flashes, press 0VJ to call back the station or voice mail device
that activated the LED (see “Message Waiting” on Page 57). This is the
telephone’s [PDN] message waiting button.
5HGLDO
Press the same [DN] or /LQH that you used to dial the original number. Press
5HGLDO. The last number called is redialed.
If you have Automatic Line Selection, you must first lift the handset.
Table 1 Fixed Button Definitions (continued)
Button Definitions
CO LINE 02
HOLD
DN 202
HOLD