Filter
Top Products
Strata DK Digital Telephone 6/00 129
➤ To transfer a call to an idle station
Call Transfer with Camp-on
You can transfer a call to a busy station from either a DSS console or an DADM. Use
the [DSS] to transfer the call, even though the [DSS] LED associated with the station
you are “transferring to” is red.
➤ To transfer call to a busy station
1. Press [DSS]
corresponding to the
station to be called.
The call is placed automatically on hold. The Line or
[DN] LED flashes green at double the on-hold rate,
and the [DSS] LED flashes green.
You hear a single-ring tone. (If using the Tone
signaling mode, you hear successive ring tones.)
2. Announce the call. With Tone signaling, you would have to wait for the
called station to answer before announcing the call.
3. Hang up. The call rings the called station when you hang up.
While the called station is ringing, the [DSS] LED is
steady red, and the Line LED flashes green at the on-
hold rate or if on a [DN] button, it goes idle.
When the called station answers the call, the [DSS]
LED stays steady red, and the Line LED becomes
steady red.
4. If the station does not
answer before a
period set in system
programming, the call
recalls your station.
1. Press [DSS]
corresponding to the
busy station to be
called.
You may hear a busy tone. The original caller is placed
automatically on hold. The Line or [DN] LED flashes
green at double the on-hold rate, and the [DSS] LED
remains steady red.