Filter
Top Products
Butler 1410
81
Butler 1410
81
Butler 1410
81
4.22. Selecting a base unit
If your handset is subscribed to a number of base stations (max 4), you must
select a base unit because a handset can only communicate with one base unit
at a time. There are two possibilities:
4.22.1. Automatic selection
- Repeatedly press the Menu key until 'TELEPHONE' appears.
- Press the OK key twice.
- Repeatedly press the Menu key until ‘SELECT BASE’ appears.
- Press 'OK' or ‘BACK’ to go back.
- 'BASE XXXX?' appears on the display (xxxx = numbers of the base unit to
which the handset is subscribed)
- Press 'AUTO' and then OK.
4.22.2. Manual selection
If you set the handset to 'manual selection', the handset will only choose the
base unit you have set.
- Repeatedly press the Menu key until 'TELEPHONE' appears.
- Press the OK key twice.
- Repeatedly press the Menu key until ‘SELECT BASE’ appears.
- Press 'OK' or ‘BACK’ to go back.
- 'BASE XXXX?' appears on the display (xxxx = numbers of the base unit to
which the handset is subscribed).
- Enter the number of the base unit (1-4) and press OK.
Notes:
- Before you can select a base unit, the handset must first be subscribed with that base
unit.
- If the base unit is not found, the handset automatically goes back to its original base
unit.
4.23. Resetting
4.23.1. Resetting base unit
Here the factory settings of the base unit are set again.
The factory settings are:
PIN: 0000
Dial mode: Tone dialling
Call sequence: Call all handsets
Butler 1410
81
handl. B1410 10/9/01 10:39 am Page 81