Filter
Top Products
39
Remote Operation
USING REMOTE COMMANDS
Whether you are using the handset or calling from a touch-tone
phone, you press the same buttons to operate the TAD. The only
difference is the way you connect with the answering system.
From a remote touch-tone phone:
Dial your phone number. When the TAD answers, enter your
remote access code. The TAD announces the number of mes-
sages and beeps twice to confirm that you entered the correct
code.
Notes
:
²
If you do not enter each digit of the remote access code
within 8 seconds, the TAD hangs up.
²
If the TAD is not set to answer calls or the memory is full, it
will answer after 10 rings.
From the handset:
Press
ANS SYS
. The ANS SYS indicator lights. The TAD
announces the number of messages and beeps twice.
After connecting with the TAD, enter a remote command (see “Re-
mote Commands” on Page 40), or press
5
to hear voice prompts,
or wait until the TAD begins playing all messages (after about 4
seconds).
When you finish, simply hang up (remote phone) or press
ANS
SYS
(SP-809’s handset).
43-5809.fm Page 39 Wednesday, August 18, 1999 1:43 PM