Filter
Top Products
15
Preparation
If the dial tone stops, you have touch-tone service. Since the
phone is preset to touch-tone service, you do not need to make
any change to the dialing mode.
If the dial tone continues, you have pulse service. Press
PHONE
PROG/MEM
#
#
#
3
.
If your phone is set for pulse service and you want to change
the dialing mode to touch-tone service, press
PHONE
PROG/MEM
#
#
#
8
.
SETTING THE DAY AND TIME
Note:
You can use the handset as well as the keys on the base to
operate the TAD. To use the handset, simply press
ANS SYS
to ac-
cess the TAD before beginning each procedure. The ANS SYS in-
dicator lights and the TAD announces the number of messages
then beeps twice.
Follow these steps to set the day and time so the TAD can record
the correct information when each message and memo is re-
ceived.
Note
: If you do not complete each step within 20 seconds, the TAD
sounds two beeps and exits setup. Start again at Step 1.
1
Press
CHANGE
then
CLOCK
. A number from
1
–
7
(the day of the week, with
1
being Sunday) appears in the
message counter window and
the TAD announces the cur-
rently set day.
Note:
The TAD’s message counter window might also alternately
show other information to tell you the status of the TAD.
CHANGE
CLOCK
43-5809.fm Page 15 Wednesday, August 18, 1999 1:43 PM