Filter
Top Products
12
Installation
INSTALLING AND CHARGING THE BATTERY PACK
The SP-809 is packaged with a rechargeable nickel-cadmium bat-
tery pack. Before using your phone, you must install the battery
pack and then charge it for 12–15 hours.
Press down and slide off the
compartment cover. Place
the battery pack into the com-
partment aligning the battery
pack with the polarity marks
(+ and –) inside. Replace the
cover.
To charge the battery pack,
simply place the handset on
the base. The CHARGING in-
dicator on the base lights.
Note:
You can place the handset on the base faceup or facedown.
Recharge the battery pack
when the LOW BATT indica-
tor on the handset flashes.
Notes:
²
When you first use the phone after charging or recharging the
battery pack, the phone might not work and you might hear a two-
beep signal when you press
TALK
. If this happens, return the
handset to the base for about 30 seconds. This resets the security
access protection code.
LOW BATT
Indicator
43-5809.fm Page 12 Wednesday, August 18, 1999 1:43 PM