Filter
Top Products
31
PJ-Net Organizer
OWNER’S MANUAL
E-mail Setting
ENGLISH
E-mail Setting
This product has an E-mail function which can send an alert message to
users or an administrator if it detects an abnormality on the projector or run
out of the life span of the lamp. Click on the E-Mail Setting linked text on the main
menu and follow the below
steps.
1 SMTP Server*
1
Type the address of SMTP
server for E-mail and press
the Set button.
2 Administrator Address
Type the E-mail address of
administrator and press the
Set button. This address is
set to "Reply-To" address
sent from the projector.
3 Registering and delet-
ing E-mail addresses
Type the E-mail address to
which an alert message is
sent and press the Add button. The registered addresses are listed on the below
column as the "Mail To" address. To delete the registered addresses, press the
Delete button next to the E-mail address you want to delete.
4 Condition selection for sending alert message
Check the condition items under which alert messages will be sent and press the
Set button.
Please refer to chapter “Examples :Type and contents of alert messages” described
on next page.
*1 The SMTP server is a server for sending E-Mail. Please contact your network administrator to
have this SMTP server address.
✐ To use the E-Mail function, it must be set the DNS address on the Network Setting page correctly.
✐ You cannot use this E-mail function if the DNS server and SMTP server cannot be used in
your network environment. If the SMTP server is located in your LAN (Local Area network),
the address set to SMTP server should be specified the in SMTP server located in your LAN.
The server located outside of your LAN may not be available for security reason. For further
information please contact your network administrator.
✐ Up to 10 e-mail addresses can be registered.