Filter
Top Products
16
Installation
Configure the network with the projector
This example explains how to set the following configuration.
IP Address : 192.200.1.201
Subnet Mask : 255.255.255.0
Default Gateway : 192.200.1.1
DNS : 0.0.0.0
A
1 Selection of network menu [PJ-Net Organizer]
Turn on the projector and display the menu on the screen. Select the PJ-Net
Organizer icon from the Setting sub menu using the pointers, and then press the
SELECT button on the remote control or on the projector. Confirm that its mode
is set On. If not, change mode to On using the pointer / .
2 Configuration for IP Address/ Subnet mask/Default Gateway*/DNS*
Press the SELECT button again, the following network setting menu appears on
the screen. Enter the specified network address. The following is an example of a
network configuration.
NETWORK SETTING
IP Address
Subnet mask
Default Gateway
DNS
192 200 1 201
255 255 255 0
192 200 1 1
0000
▲
▲
* In the network environments not using a Gateway or Router, the Default Gateway address
should be set to [0.0.0.0]. If you do not use the functions E-mail or DNS server, it is also set
[0.0.0.0] for the DNS address.
* The above on-screen display may differ from
the actual display depending on the functions
of the projector you use.