Filter
Top Products
9
Connections and Setup
Base Station
The phone must be connected to two line (RJ14C) wall jacks or four single line
(RJ11C) wall jacks to accomodate all four lines.
IMPORTANT: Connect the AC power supply to the base unit as out
lined in steps 1 through 3 below prior to connecting the telephone line
cords to insure for proper base station ID assignment.
1. Choose an area near an electrical outlet and a telephone wall jack, and place
your cordless telephone on a level surface, such as a desktop or tabletop.
2. Plug the power supply cord into the power jack on the back of the base and
the other end into an electrical outlet.
T-T009 power adaptor listed in the user’s guide.This power adaptor is
3. Connect the telephone line cords:
of the straight telephone line cord tagged as “LINE 1+2” into the jack marked
LINE 1 + 2 and one end of the other straight line cord into the jack marked LINE
3 + 4 on the back of the base. Plug the other end of each line cord into the dual-
line wall jacks.
use adaptors or couplers (not included) to combine the four single telephone
lines into two dual lines. The adaptor/coupler may look similar to the one pic-
tured here and can be purchased from your local telephone products retailer.