Filter
Top Products
14
Connections and Setup
Handset Charge Cradle
connection errors. The phone must be connected to the power outlet, Line 1 must be
connected to the Line 1 + 2 jack, and the phone must have a unique phone ID.
NOTE: For instructions on how to change your phone’s unique ID, see Phone ID, page 17.
VERY IMPORTANT: In order to achieve full system operation (i.e. intercom, page, etc.), Line
1 must be connected and common to all phones on the system. Only other 25420,25423,
25424, 25425, 25413, 25414, 25415, 25403 and 25404 models are fully compatible.
Other System Phones
1. Press Line 1.
2. Look at all the other stations. If they all indicate line 1 is being used, the connection
is correct.
OR
1. Press the Intercom button. The display shows SELECT PHONE ID.
2. Use the keypad to enter the phone ID. The display shows the phone ID you entered. If
the phone ID you entered is connected to the system, you will hear a ring back tone
(call through tone) at your phone. If the phone ID is not connected to the system, you
will hear an error tone. NO ANSWER shows in the display and intercom is cancelled.
Programming the Telephone
When programming the phone, if at any time you wish to discontinue or stop
programming, press the “Exit” button. Also , whenever you have made a program
selection by pressing the Sel/Save button the display will shown “Saved” for several
seconds then will return to the MAIN MENU prompt display.
Language
1. Press the Menu button once, LANGUAGE will show in the display.
2. Press the Select/Save button to select.
3. Press the VOL ( or ) button on the handset to select ENGLISH, FRANCAIS, or
ESPANOL. The default is “ENGLISH”.
4. Press the Select/Save button again to store the setting.
Volume
The ringer, speaker, and handset/headset volumes are set independently with the
Vol (+ or -) buttons. There are 5 possible volume settings per mode. The volume
level is displayed during volume adjustment.