Filter
Top Products
35
Other Information
• The cordless handset may be out of range of the base. Move closer to the base.
• Charge the battery.
Unit beeps
• Clean charging contacts on cordless handset and charge cradle with a soft cloth or an
eraser.
• See solutions for “No dial tone” on previous page.
• Replace the battery.
Memory Dialing doesn’t work
• Did you program the memory location keys correctly?
• Did you follow proper dialing sequence?
Unit locks up and no communication between the base and cordless handset
• Unplug the AC power adaptor from the wall outlet and the back of the base, and
remove the backup batteries from the bottom of base (if previously installed). Remove
the handset battery. Wait for 30 seconds and plug the power adaptor back into the
base and wall out, and re-install batteries in the base unit. Reconnect the handset
battery and charge for 14 hours.
Caller ID Solutions
No Display
• Is battery fully charged? Try replacing the battery.
• Make sure that the unit is connected to a non-switched electrical outlet. Disconnect
the AC power supply from the base and reconnect it.
Caller ID Error Message
• The unit displays this message if it detects anything other than valid Caller ID
information during the silent period after the rst ring. This message indicates the
presence of noise on the line.
No Caller ID
• In order to receive Caller ID information, you must subscribe to the standard name/
number Caller ID service from your local telephone company.
Battery Solutions
If you experience any of the following problems, even after fully recharging the battery,
you may need to replace the battery pack:
• Short talk time
• Poor sound quality
• Limited range